This Bracket is to fit a 2JZ-GE Head with both stock valve covers and GTE valve covers.
 
These fit Yaris coils and R35 GTR Coils. Please choose the option you want carefully. Remember R35 coils DO NOT have IGF (ignition feedback), so you must choose Yaris Coils if you want to run a Stock GTE ECU. R35 coils must be run with an aftermarket ECU and will come with boots to fit the bracket.
 
When using GTE valve covers, the GTE plastic engine cover will also fit as stock on top with both coil options. You can also retain the two breather tubes in the center. 
 
Fitting instructions
This new Bracket design is very fast to fit. Simply remove the four center valve cover bolts, and lay the stands provided for the Yaris coils onto the bolt holes. Place the bracket on top and tigten bolts. 
The R35 GTR coil bracket has no stands but does come with boots that will replace the stock Coil boots. To fit these, carefully remove the stock boots from your coils by twisting them off. They are made to come apart, but be careful as the resistor will fall out once the boot is seperated. Best to do this sitting down at a table so the resistor falls to the table rather than concrete floor. Put the resistor back in to the coil head and fit the new spring and boot. You will feel and hear the click once the new boot has connected correctly. 
You can bolt the coils to the bracket before or after fitting to the engine, and the wiring harness can also be pre fit. Just remember the heater hose can obstruct number six cylinder if fitting with the engine in the car.